Silent Call GV1097-2 - Manual (Page 2)

NOTE:
Your Good Vibration receiver and all transmitters leave the factory already programmed for the factory default code. The
Good Vibrations does NOT need to be programmed unless you have changed the code on your transmitters.
The Silent Call alerting system is digitally coded. Each Silent Call transmitter contains a nine position code switch. Positions 1
through 5 on the transmitter set the address. If the transmitter has the 9 position dip switch LEAVE POSITIONS 6, 7, 8, AND 9 AS
IS. .Position 6 through 9 set the type of alert function and does not require programming. The Good Vibration receiver can be
set to respond to one or more different transmitter codes. All Silent Call transmitters and receivers leave the factory set to the default
code of 1=off, 2=off, 3=off, 4=on, 5=on. This code does not need to be changed unless your system is within 100-200 feet of another
Silent Call system. In that case, simply set all transmitters to a different code (any combination of on and off positions except all on or
all off), erase the code memory in the Good Vibration, and then reprogram the Good Vibration receiver as follows:
To erase all programmed codes:
1. Turn the Good Vibration off.
2. Open the access battery door on the back of the Good Vibration and locate the PROGRAM button.
3. Press and hold the PROGRAM button. While pressing the program button, turn the Good Vibration on, hold on until all LEDs
light and then release the PROGRAM button. This will erase all codes in the Good Vibration’s memory.
To program a new code:
1. With the Good Vibration turned ON, press the program button. All four LEDs will illuminate. Hold the program button until the
LEDs go out (about 8 seconds). Release the button and the LEDs will come back on to indicate that the Good Vibrations receiver
is in program mode. It will remain in program mode for approximately 30 seconds and the LEDs will go out one at a time to
indicate the time remaining. While in program mode, the Good Vibrations will memorize the code of the first transmitter it
receives and then exit program mode.
2. While the Good Vibration receiver is in program mode, press the button on any Silent Call transmitter that has been set to the
desired system code. When the Good Vibration receiver receives the coded transmitted signal, it will memorize the code, exit
program mode and indicate the function of the transmitter. The Good Vibration receiver can memorize an unlimited number of
system codes.
3. Note that you do not have to program the Good Vibration receiver with every transmitter in your system as long as all transmitters
are set to the same code.
Programmed codes are retained in memory even when the Good Vibrations battery is removed.
Technical Support
For technical support on this or any other Silent Call product, please feel free to contact us. You can reach us by phone at 800-572-
5227 (voice or TTY) or by Email at
[email protected]
Limited Warranty
Your Good Vibrations receiver is warranted to be free of defects in material and workmanship for five years from the date of initial purchase (not
including the battery). During that time, the unit will be repaired or replaced free of charge when shipped prepaid to Silent Call Communications.
To obtain warranty service, contact Silent Call to obtain return materials authorization. Please include your telephone number or other ways we can
contact you. This warranty is void if the defect is caused by customer abuse or neglect.
Program Button
5095 Williams Lake Road, Waterford, MI 48329
(248) 673-7353 v/tty (248) 673-7360 fax (800) 572-5227 v/tty
Email:
[email protected] website: www.silentcall.com