Technical support, Limited warranty – Silent Call OP1097 User Manual
Page 2
3. Press and hold the PROGRAM button. While pressing the program button, turn the Omni Pager on, hold on for 8 – 10 seconds
and then release the PROGRAM button. This will erase all codes in the Omni Pager’s memory.
To program a new code:
1. With the Omni Pager turned on, press the program button. Hold the program button for about 8 – 10 seconds. Release the button
as now the unit is in program mode. It will remain in program mode for approximately 30 seconds. While in program mode, the
Omni Pager will memorize the code of the first transmitted signal received and then exit program mode.
2. The Omni Pager receiver can memorize an unlimited number of system codes.
3. Note that you do not have to program the Omni Pager receiver with every transmitter in your system as long as all transmitters are
set to the same code.
Programmed codes are retained in memory even when the Omni Pager’s battery is removed.
Technical Support
For technical support on this or any other Silent Call product, please feel free to contact us. You can reach us by phone at 800-572-
5227 (voice or TTY) or by Email at
Limited Warranty
Your Omni Pager receiver is warranted to be free of defects in material and workmanship for five years from the date of initial
purchase (not including the battery). During that time, the unit will be repaired or replaced free of charge when shipped prepaid to
Silent Call Communications. To obtain warranty service, contact Silent Call to obtain return materials authorization. Please include
your telephone number or other ways we can contact you. This warranty is void if the defect is caused by customer abuse or neglect.
Program Button
5095 Williams Lake Road, Waterford, MI 48329
(248) 673-7353 v/tty, (248) 673-7360 fax, (800) 572-5227 v/tty
Email: