Silent Call WCV08-SS - Manual (Page 3)

All of your Signature Series transmitters come pre-programmed from the factory to work with your “Silent Touch”
watch Receiver. If you need to set your transmitters to a different address, please refer to the section in this
manual on programming transmitters. The only reason you would need to do this is if someone in your area is using
Silent Call products and they are interfering with your products or if you want to use the Supervision Capability with
your Silent Call Smoke Detectors and/or Fire Transmitters.
Programming the transmitters:
1. Make sure that all Silent Call transmitters in the area are turned off.
2. Perform the ALL ERASE function (see below)
3. Select the transmitter you wish to program with the “Silent Touch” Watch Receiver
4. Located on the back of the transmitter case is a removable access panel. Remove the access panel and take
out the batteries. Note that you MUST remove the batteries first or the switch setting will
not take effect.
5. Locate the switch on the transmitter circuit board that has 5 small dip switches.
6. Set the switches to any combination that you want. For Example: 1, 2 On 3,4,5 OFF. (Do not
set them to all ON or all OFF as this can cause interference). This gives your transmitter an
“address”.
7. Reinstall batteries and replace the access panel.
8. Make sure that the transmitter is near the “Silent Touch” watch Receiver for programming.
9. On the “Silent Touch” Watch Receiver, press and hold SW # 2 pushbutton until the “PPP” is
displayed on the screen. This means you are now in program mode.
10. On the transmitter, press the test button so that it sends a signal to the Silent Touch Watch Receiver. The unit
will vibrate a specific designed vibrator pattern, and display the Icon for the transmitter that you used. Your
transmitter is now programmed to work with your receiver.
11. Repeat the above steps ONLY if the other transmitters are set to a DIFFERENT address setting than the
transmitter you just programmed. We recommend keeping all of your transmitters set to the same address
to reduce interference from other Silent Call systems that may be in your area.
All Erase
The ERASE ALL function clears the watch memory of all stored transmitter addresses. The watch will no
longer be programmed to receive an alarm signal once all memory is erased.
To erase the alarm code memory:
1. Place the “Silent Touch” Watch in the charger /docking station.
2. Using a small object such as a pen or paper clip, press and hold the erase button (located on the side of the
charger case). See Fig 3.
3. Press and hold the recall alarm pushbutton (located on the top of the charger case). See Fig 4.
4. While continuing to hold the recall alarm button, release the erase button.
5. Release the recall alarm pushbutton. The previously learned addresses are now erased from the watch
memory.
SW3 button
SW2 button
Fig. 3 Fig. 4