Sioux Chief Add-A-Line and Replace-A-Valve - Manual

Add-A-Line ™
Replace-A-Valve ™
AAL/RAV TRAINING SHEET – 3/07 © 2007 SIOUX CHIEF MANUFACTURING
www.siouxchief.com 1-800-821-3944
Perfect for adding ice
makers, humidifi ers,
hot water taps, or
fi ltered water taps
Easy to install
Quality brass valve
replaces cheap saddle
valve that leaks and clogs
Never worry about
leaking valves again
•
•
•
•
Turn off house water. With a
permanent marker, mark the tube
at either end of the brass thread
fi ttings.
Cut out a 1" section of pipe between
innermost marks.
Slide compression nut and brass
ferrule over each section of tube.
Center Add-A-Line over cut out
section of tube, using marks as a
guide.
Slide nut and ferrule over the tube,
with the narrow end of ferrule
toward the valve. Tighten nut onto
the threads. DO NOT overtighten.
Use one wrench to tighten each
compression nut on trunk while
holding the Add-A-Line with another
wrench. DO NOT over-tighten.
Turn on house water and check for
leaks.
1 2
4 3
5 6
Tighten
Hold
Hold Tighten
Narrow end
to valve
Turn off house water. With a
permanent marker, mark the tube
at either end of each brass fi tting of
the Replace-A-Valve.
Cut out the leaky valve at the inner
marks.
Slide a compression nut and a brass
ferrule over each section of cut tube.
Then, slip the Replace-A-Valve over
one section of tube, then the other,
lining up the compression threads
with the outer marks.
With two wrenches, tighten each
compression nut. DO NOT over
tighten.
Turn on house water and check for
leaks.
1 2
4 3
5
Hold Tighten
Full-slip tailpiece slides over existing
tube. No additional fi ttings needed
Easily add or replace an in-line valve to
any existing copper line
No torch required with
compression model
Installs in minutes—house water
off for only a short time
Quality full port
¼-turn ball valve
•
•
•
•
•