TotalPond LL1200 User Manual
Page 2
2
PREPARATION
Before beginning assembly or operation of product, make sure all parts are present. Compare parts with
package contents list and diagram above. If any part is missing or damaged, do not attempt to assemble,
install or operate the product. Contact customer service for replacement parts.
•
Estimated Assembly Time: 5 minutes
•
Tools required for assembly: hacksaw.
OPERATION INSTRUCTIONS
1. For maximum water flow, it is recommended that the largest
tubing size for your pump is used. If using 1 in. ID tubing,
proceed to step 2. If using 1-1/2 in. ID tubing, cut the adapter as
shown using a hacksaw. Fig. 1
Fig. 1
2. Connect tubing to the outlet of the pump using an adapter.
Fig. 2
NOTE: Tubing is NOT INCLUDED.
Fig. 2
3. Place the pump inside the pump barrier bag. Pull the drawstring
until the pump barrier bag is fully closed around the tubing and
power cord. Tie a knot in the drawstring. Fig. 3
Fig. 3
4. Place the pump into the water and connect to a proper power
source. Fig. 4
Fig. 4
GFCI
Cut ring
Tubing
Adapter
Pump