TotalPond A16531L User Manual
Page 4
7. Place the pump inside the container and run the cord though the
newly drill hole. Seal the hole around the cord with epoxy putty and
allow it to harden. Fig. 7
NOTE 1: Wearing gloves when mixing the putty is recommended.
NOTE 2: For best adhesion, clean and roughen bond area.
NOTE 3: Cut off required epoxy putty. Twist and knead until a
uniform color is achieved (no streaks). Apply to the hole around the
cord. Working time is 15 minutes until hardening begins. After
approximately 1.5 hours the epoxy putty will fully harden.
Fig. 7
8. Test fit the assembled container fountain kit in the container. Fill
the container with water, 2/3 up to the top. Fig. 8
Fig. 8
9. If needed, attach the extensions to the bottom of the filter box.
Fig. 9
Fig. 9
10. Connect the pump to a proper power source. Fig. 10
Fig. 10
GFCI
Epoxy Putty
Epoxy Putty