Cyborg V.3 Game Pad - Manual (Page 3)

3
Installation - Cyborg ® V.3 Rumble for PC, PS2 and PS3
Plug in your Controller
Insert the USB Cable into one of your PC or PS3’s USB ports or PS2 cable into one of your PS2’s ports.
The FPS (Home) button
Most First Person Shooter (FPS) games on the PC don’t support gamepads without complex programming of
controls. However, the Cyborg
® V.3 Rumble FPS feature allows you to use your gamepad in an FPS game at the
touch of a button.
Pressing the FPS gaming button (b) automatically sets up the pad’s controls for the commands found in most current
FPS genre games. You must install both product drivers and Smart Technology (ST) Programming software (from
www.cyborggaming.com) for the FPS button to work.
PS3 installation
When first plugging into the PS3, press the home button (b) to activate the pad. The home button (b) will activate the
PS3 menus only in PS mode.
Features
Switch between PC and PS2/PS3 operation by pressing the mode button (a) at the top of your gamepad. The LED’s
will light green when in PC mode and red when in PS2/PS3 mode.
To operate the Precision Aim Button, press and hold this button on the underside of the pad to half the sensitivity of
the right Mini Stick. Release the button to resume normal sensitivity.
To swap the position of the left Mini Stick and D-Pad, press the release button on the left underside of the gamepad
to unclip the Cyborg
® module. Pull out the Cyborg ® module and rotate the unit, then clip back into place.
Please note the Rumble Force will only work on the PC and PS2 formats.