Vollrath Cayenne Sandwich Presses - Manual (Page 3)

C
ountertop
C
ooking
e
quipment
3
ENGLISH
O
peratOr
’
s
M
anual
D HEIGHT ADJUSTMENT. This is an adjustable rod that limits or
restricts the downward stop position of the top grill plate.
E LOCK NUT. Used to lock the position of the height adjustment.
F THERMOSTAT CONTROL dial. Used to set or adjust the temperature
of the grill plates. The numbers on the dial correspond with the grill
plate temperature. The “0” position is off.
G PILOT LIGHT. This light indicates that the element is heating. Once
the set temperature has been reached the light will go out. Unit will
continue to maintain heat and temperature with the light cycling on and
off. This is not a power indicator light.
H DRIP TROUGH. Opening located on the bottom grill plate for grease or
oil to drain out.
I DRIP CUP. A container under the grease trough that collects grease,
oil and liquid from the grease trough.
o
Peration
WARNING
Burn Hazard.
Do not touch hot food, liquid or heating surfaces
while unit is heating or operating.
Hot surfaces and food can burn skin. Allow the hot surfaces to cool
before handling. Do not drop or spill water into the cooking surface
as it can spray or splatter.
Before initial use, turn the thermostat control to the maximum setting, close
the lid and allow unit to burn in for 30 minutes. You may notice smoke
appearing due to the cooking surface burning in. This is normal. After 30
minute burn in period the unit is ready for use.
To adjust the self leveling grill plates:
1. Center the food product on the bottom grill plate (C) and lower the top
grill plate (B). See Figure 1.
2. Adjust the height adjustment (D) until the desired level is reached. Turn
the lock nut (E) to set the position of the height adjustment (D).
To begin heating or cooking:
1. Preheat unit to desired temperature.
2. Use handle (A) to lower top grill plate (B) to desired height. Heat or cook
for desired length of time.
WARNING
Electrical Shock Hazard.
Keep water and other liquids from entering the
inside of the unit. Liquid inside the unit could cause
an electrical shock.
Do not spray water or cleaning products. Liquid could contact the
electrical components and cause a short circuit or an electrical
shock. Do not use unit if power cord is damaged or has been
modified
3. At the end of each cooking cycle wipe down the cooking plates. Never
allow excess fat, oil, or grease to build up as this will result in a build-up
of carbon on the plates.
4. Ensure the drip cup provided is in place on the back of the unit during
operation. Empty the grease cup periodically to ensure it does not
overflow.
c
leaning
To maintain the appearance and increase the service life, clean your unit
daily.
WARNING
Burn Hazard.
Do not touch hot food, liquid or heating surfaces
while unit is heating or operating.
Hot surfaces and food can burn skin. Allow the hot surfaces to cool
before handling. Do not drop or spill water into the cooking surface
as it can spray or splatter.
NOTE:
Do not clean the unit with steel wool.
1. Allow the unit to cool completely before cleaning.
WARNING
Electrical Shock Hazard.
Keep water and other liquids from entering the
inside of the unit. Liquid inside the unit could cause
an electrical shock.
Do not spray water or cleaning products. Liquid could contact the
electrical components and cause a short circuit or an electrical
shock. Do not use unit if power cord is damaged or has been
modified
2. Unplug the unit.
3. Do not immerse the cord, plug or unit in water or any other liquid.
4. Wipe grease or oil to the drip trough (H) and into the drip cup (I). See
Figure 1.
5. Using a damp cloth or sponge dipped in soapy water, clean the unit and
plates; rinse thoroughly.
6. Dry thoroughly after cleaning.
7. Empty and clean the drip cup (I).