Kodak M873 - Manual (Page 57)

Troubleshooting
www.kodak.com/go/support 51
Picture quality problems
Slide Show does not
run on an external
video device ■ Adjust the camera Video Out setting to NTSC or PAL ( see
page 32 ).
■ Make sure the external device settings are correct. (See the
device’s user’s guide).
Computer does not
communicate with
the camera ■ Make sure the battery is charged and installed correctly (see
page 1 ).
■ Turn on the camera.
■ Make sure the USB cable model U-8 is connected to the camera
and the computer (see
page 45 ). (If using an EasyShare dock,
check all cable connections. Make sure the camera is seated on
the dock.)
■ Make sure EasyShare software is installed (see page 44 ).
Status Solution
Picture is not clear ■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
■ Clean the lens (see page 57 ).
■ Make sure the camera is not in Macro mode if you are more than
27.6 in. (70 cm) from your subject.
■ Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
Picture is too dark ■ Reposition the camera for more available light.
■ Use Fill flash (see page 9 ) or change your position so light is not
behind the subject.
■ Move so that the distance between you and the subject is within the
effective flash range. (See camera specifications starting on
page 55 .)
■ To automatically set exposure and focus, press the Shutter button
halfway. When the framing marks turn green, press the Shutter
button completely down to take the picture.
Status Solution