Kodak V610 User Manual
Page 64
58
www.kodak.com/go/support
Troubleshooting
Picture quality problems
Status
Possible Solutions
Picture is not clear
■
To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light turns green, press the Shutter
button completely down to take the picture.
■
Clean the lens (
■
Make sure the camera is not in Close-up mode if you are more than
27.6 in. (70 cm) from your subject.
■
Place the camera on a flat, steady surface or use a tripod (especially
in high-zoom settings or in low light).
Picture is too dark
■
Reposition the camera for more available light.
■
Use Fill flash (
) or change your position so light is not behind
the subject.
■
Move so that the distance between you and the subject is within the
effective flash range (
).
■
To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light turns green, press the Shutter
button completely down to take the picture.
Picture is too light
■
Reposition the camera to reduce the amount of available light.
■
Turn the flash off (
).
■
Move so that the distance between you and the subject is within the
effective flash range (
).
■
To automatically set exposure and focus, press the Shutter button
halfway. When the Ready light turns green, press the Shutter
button completely down to take the picture.
■
In Auto and Scene-Custom modes, adjust the Exposure
Compensation (
).