Configuring system update, Configuring system update with the registry – Lenovo System Update Solution (Deployment Guide) User Manual

Page 20

Advertising

Configuring System Update

Configurations for System Update can be done through the registry, Active
Directory

, or the start.reg file. If you are configuring just one system, you can use

the registry to configure System Update. If you are configuring multiple systems,
you can use Active Directory to configure policies for System Update. If your
enterprise does not use Active Directory, Lenovo provides the start.reg file that you
can configure and then deploy to multiple systems. For additional information
about each configuration method, see the following sections:

“Configuring System Update with the registry”

“Configuring System Update with Active Directory” on page 28

“Configuring System Update with start.reg” on page 35

Configuring System Update with the registry

To edit registry configurations, close the System Update application. If System
Update is running while changes are made in the registry, the old registry entries
will be recovered. After the first launch of System Update, the configurable items
for System Update that can be modified are in the following registry locations:

Table 5. Registry locations

Setting

Registry location

Disable the System Update billboard

, see

“UC Settings configurable items” on page
15.

HKLM\SOFTWARE\Lenovo\System
Update\Preferences\UCSettings\General

Disable registration on billboard

HKLM\Software\Lenovo\Registration\
RegStatus

Disable System Updates user interface

, see

“UC Settings configurable items” on page
15.