Installing the adapter, Attaching media, Installing the adapter attaching media – Lenovo ThinkServer TD340 User Manual

Page 12

Advertising
background image

LPe16000 Series HBA Installation Manual

P007648-01A Rev. A

2. Installation

Installing the Adapter

11

Note: Be careful not to push the bracket past the transceiver. Ensure the light

emitting diodes (LEDs) are properly aligned with the holes in the bracket.

9. Re-install the screws that attach the HBA to the bracket.
10. Re-install the transceiver by sliding it into the housing. When the latch engages, it

clicks.

11. Push the bail back into place.

Installing the Adapter

1. Turn off the computer if hotplug is not supported on the server. See your server

documentation to see if it supports Hot Plug/Hot Swap of PCIe adapter cards.

2. Remove the computer case.
3. Remove the blank panel from an empty PCIe bus slot. See “Preparing the HBA for

Installation” on page 8 to change the brackets if needed. Otherwise, proceed to

“Attaching Media” on page 11.

Note: Place the HBA into an empty PCIe x8 or x16 slot. Make sure that the adapter

is in an appropriate PCIe slot that does not interfere with other components

or case to prevent damage to the HBA.

4. Insert the HBA into the empty x8 or x16 PCIe bus slot. Press firmly until the adapter

is seated.

5. Secure the HBA mounting bracket to the case with a panel screw or clip.
6. Replace the computer case and tighten the case screws.
The HBA is now installed in the server and is ready for media attachment.

Attaching Media

Use multimode fiber optic cable, with short-wave lasers, that adheres to the following

specifications:

Note: The HBA will not allow normal data transmission on an optical

link unless it is connected to another similar or compatible laser

product (that is, multimode to multimode.)

Note: The HBA will not automatically downgrade to the required FC

speed based on cable length. You must downgrade the speed

with the appropriate utility or link errors may occur.

Table 2-1 Media Specifications

Fiber Optic Cable

Maximum Length

Minimum Length

Connector

OM4 - Multi-mode 50/125
micrometer fiber (4700 MHz*km
bandwidth cable)

4GFC: 0.5m - 400m
8GFC: 0.5m - 190m
16GFC: 0.5m - 125m

0.5 meters

LC

Advertising
This manual is related to the following products: