Lenovo Y50-70 Touch User Manual

Page 2

Advertising
background image

2

• FCC ID: PD97260NGU (Model: 7260NGW)
• FCC ID: QDS‐BRCM1076 (Model:BCM94352Z)

Wireless LAN Mini PCI Express Cards marketed in the USA and Canada do not support nor 
function in the extended channels (12ch, 13ch). 

i) The FCC RF Exposure compliance:
The radiated output power of the Wireless LAN Mini PCI Express Card authorized to use for 
the your Lenovo computer is far below the FCC radio frequency exposure limits. Neverthe‐
less, it shall be used in such a manner that the potential for human contact during normal 
operation is minimized as follows:

ii) FCC ID of wireless module: 
On the bottom side of your Lenovo computer, you will find an indicator label of the format 
“Contains Transmitter Module: FCC ID XXXX”, where XXXX represents the FCC ID that corre‐
sponds to your preinstalled Wireless LAN module. 

iii) Radio Frequency interference requirement: 
Each device has been tested and found to comply with the limits for a Class B digital device pur‐
suant to FCC Part 15 Subpart B. Refer to “Electronic emission notices” on page 5

When you use a wireless LAN module in the 802.11 a/n transmission mode:
• Each device is restricted to indoor use due to its operation in the 5150 to 5250 MHz 

frequency range. FCC requires these products to be used indoors for the frequency range 
5150 to 5250 MHz to reduce the potential for harmful interference to co‐channel Mobile 
Satellite systems.

• High power radars are allocated as primary users of the 5250 to 5350 MHz and 5650 to 

5850 MHz bands. These radar stations can cause interference with and/or damage this 
device.

II. Simultaneous use of RF transmitters
Make sure of the following conditions on use of wireless features:
1. When you use any other RF option device, all wireless features in your Lenovo computer 

are required to be turned off.

2. Users must follow the RF Safety instructions on wireless option devices that are included 

in the RF option deviceʹs userʹs manual.

Caution:

To comply with FCC RF exposure compliance requirements, a separation distance of at least 
20 cm (8 inches) must be maintained between the antennas connected to the wireless module 
and all persons. If the distance may not be maintained while the computer display is closed, 
you must set sleep as the power mode when closing the display.

Advertising
This manual is related to the following products: