Lenovo D186 Wide Flat Panel Monitor - Manual (Page 12)

Chapter 2.
2-3
Adjusting your monitor image
This section describes the user control features for adjusting your monitor image.
Using the direct access controls
The direct access controls can be used when the On Screen Display (OSD) is not
displayed.
Using the On-Screen Display (OSD) controls
To adiust the settings, the user controls can be viewed through the OSD.
To use the controls:
1. Press to open the main OSD menu.
2. Use or to move among the icons. Select an icon and press to access that
function. If there is a sub-menu, you can move between options using or ,
then press to select that function. Use or to make adjustments. Press to
save.
3. Press to move backwards through the sub-menus and exit from the OSD.
4. Press and hold for 10 seconds to lock the OSD. This will prevent accidental
adjustments to the OSD. Press and hold for 10 seconds to unlock the OSD and
allow adjustments to the OSD.
Table 2-1. Direct access controls
Icon Control Description
Image Setup Activates automatic image adjustment
Brightness Direct access to Brightness adjustment
5. Enables DDC/CI by default. Use OSD Exit Key,Press and hold the buttons for
10 seconds to disable / enable DDC/CI function. The words " DDC/CI disable" shows
on the screen.