Lenovo 62 Desktop - Manual (Page 95)

4. Remove all memory modules and PCI cards that are currently installed. See “Installing or replacing a
memory module” on page 80 and “Installing or replacing a PCI card” on page 76.
5. Carefully take note of the locations of all cable connections on the system board and disconnect all
the cables. See “Locating parts on the system board” on page 71.
6. Remove the heat sink and fan assembly from the failing system board. See “Replacing the heat sink and
fan assembly” on page 84.
7. Remove the six screws that secure the system board.
Figure 25. Removing the six screws that secure the system board
8. Carefully slide the system board so that it can be released from the mounting studs that secure the
system board in place.
9. Lift the system board out of the chassis.
10. Remove the microprocessor from the failing system board and install it on the new system board.
See “Replacing the microprocessor” on page 87.
11. Install the new system board into the chassis by aligning the six mounting studs in the chassis with the
corresponding holes in the new system board. Carefully slide the new system board into the chassis until
it is secured in place by the mounting studs. Then, install the six screws to secure the system board.
12. Install the heat sink and fan assembly and connect the heat sink and fan assembly cable to the new
system board. See “Replacing the heat sink and fan assembly” on page 84.
13. Install all memory modules and PCI cards removed from the failing system board on the new system
board. See “Installing or replacing a memory module” on page 80 and “Installing or replacing a PCI
card” on page 76.
14. Reconnect all remaining cables to the system board. See “Locating parts on the system board”
on page 71.
Chapter 9 . Replacing FRUs 91