Advent CAM330 - Manual (Page 8)

8
Obtaining Reverse Power
1. Locate the reverse lamp in the tail light assembly.
2. Using the tap connector supplied, perform the following steps:
a) Place the un-stripped positive lead from the tail lamp in the run
channel, which runs completely through the connector.
b) Insert the un-stripped red power wire from the camera
completely into the other channel in the connector.
c) Make the connection between the wires by crimping down the
metal connector with a pair of pliers, making sure the metal is
flush with the plastic insulator.
d) Close the top plastic hinged cover until latched.
3. Attach the black wire to the ground (negative).
4. Repeat the above steps for the red wire.
Connecting the Video Signal
1. If used with an Advent LCD Monitor such as LCD4WM or LCDM42
the camera power and signal will be provided through a single cable
to the monitor (supplied with the monitor).
2. If using an alternative monitor, use the adaptor harness to split the
signal to RCA connections then connect to the female RCA input on
the alternative monitor.