Lenovo ThinkServer RD540 - Manual (Page 37)

8200 Series Converged Network Adapter and 3200 Series Intelligent Ethernet Adapter Page 19
12. Select the Boot Sequence option, and then press the ENTER key.
13. Select the Embedded NIC 1 QLogic PXE... entry, and then press the UP ARROW key to move this
entry to the first position (Figure 6).
Figure 6: Embedded NIC 1 QLogic PXE
14. Press the ESCAPE key, and then select Save changes and exit.
The system reboots.
15. After the system reboot, follow the screen prompt for PXE boot server for the installation of OS of your
choice.
Configuring Driver Software Parameters
Linux NIC Driver Management Applications
The following sections describe how to configure and manage the driver and adapter using the qaucli and
ethtool Linux management utilities.
qaucli Utility
Install QConvergeConsole CLI (qaucli) from the following packages supplied by QLogic:
• QConvergeConsoleCLI-<version>_linux_<arch>.install.tar.gz—Package file
• QConvergeConsoleCLI-<version>_<arch>.rpm—RPM installer package file
Example RPM Package Installation To determine if QCC is installed and to find the full name of the
installed QCC RPM package, issue the following command using the partial name
QConvergeConsoleCLI
as an argument to grep:
rpm –qa | grep QConvergeConsoleCLI
1. To check for an older version of the RPM package, issue the following command:
rpm –qa QConvergeConsoleCLI
2. If an older version is found, erase that version by issuing the following command:
rpm –e QConvergeConsoleCLI