Passwords, Power-on password, Supervisor password – Lenovo G560 Notebook User Manual

Page 28: Lenovo g560 hardware maintenance manual

Advertising
background image

24

Lenovo G560 Hardware Maintenance Manual

When you use the recovery discs to boot your computer, the system will enter

the user interface for system recovery automatically. Please follow the prompt

to insert the backup discs to complete the whole recovery process.

Note:

The recovery process might take up to 2 hours.

Passwords

As many as two passwords may be needed for any Lenovo computer: the

power-on password (POP) and the supervisor password (SVP).
If any of these passwords has been set, a prompt for it appears on the screen

whenever the computer is turned on. The computer does not start until the

password is entered.
Exception: If only an SVP is installed, the password prompt does not appear

when the operating system is booted.

Power-on password

A power-on password (POP) protects the system from being powered on by

an unauthorized person. The password must be entered before an operating

system can be booted.

Supervisor password

A supervisor password (SVP) protects the system information stored in the

BIOS Setup Utility. The user must enter the SVP in order to get access to the

BIOS Setup Utility and change the system configuration.

Attention: If the SVP has been forgotten and cannot be made available to

the servicer, there is no service procedure to reset the password. The system

board must be replaced for a scheduled fee.

Advertising