Lenovo IdeaCentre Q200 - Manual (Page 38)

35
Hardware Replacement Guide
4. Disconnect the failing mouse cable from the computer.
5. Connect the new mouse cable to the connector.
6. Refer to the “Completing the installation.”
Replacing the External speaker
1. Remove any media (diskettes, CDs, or tapes) from the drives, shut down the
computer, and turn off all attached devices.
2. Unplug all power cords from electrical outlets.
3. Locate the Speaker. Refer to “Locating connectors on the rear of the computer”
and “Locating connectors on the front of the computer”. Your speaker might be
connected to the Audio connector to a Audio connector at either the front
or rear of the computer. Locate the connector for the speaker.
4. Disconnect the failing speaker cable from the computer and connect the new
speaker cable to the same connector.
5. Refer to the “Completing the parts replacement”.
Completing the installation
After replacing the parts, you need to close the computer cover and reconnect
cables, including telephone lines and power cords. Also, depending on the part
that was replaced, you might need to confirm the updated information in the Setup
Utility program. Refer to “Starting the Setup Utility” in the User Guide or in the
Hardware Maintenance Manual
.
To complete the part installation:
1. Ensure that all components have been reassembled correctly and that no tools
or loose screws are left inside your computer. Refer to “Locating components”
for the location of the various components.
2. Make sure that the cables are routed correctly before replacing the computer
cover.
31032756_HaWaii-HRG_EN.indd 35 2008.1.8 3:31:43 PM