Lenovo S710 All-in-One - Manual (Page 92)

5. Locate the memory slots on the system board. See “Locating major FRUs and CRUs” on page 63.
6. Remove the system board shield to get access to the battery. See “Removing and reinstalling the
system board shield” on page 76.
7. Remove any parts and disconnect any cables that might prevent your access to the memory slots.
8. Do one of the following:
• If you are replacing a memory module, open the retaining clips and remove the old memory module
that is currently installed.
Figure 28. Removing a memory module
• If you are installing a memory module, open the retaining clips of the memory slot into which you
want to install the memory module.
9. Insert the notched end 1 of the new memory module into the slot. Press the memory module firmly
and pivot the memory module until it snaps into place. Make sure that the memory module is secured
in the slot and does not move easily.
Figure 29. Installing a memory module
10. Reinstall the system board shield. See “Removing and reinstalling the system board shield” on page 76.
11. Go to “Completing the parts replacement” on page 96.
86 Lenovo S710 All-In-OneHardware Maintenance Manual