Step five: load the mms server into the rack – AMX Rack Rail Kit MMS Servers User Manual
Page 2
AMX Corporation reserves the right to alter specifications without notice at any time.
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
065-004-2842 1/05 ©2005
AMX Corporation. All rights reserved. The AMX logo is a trademark of AMX Corporation.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax 469.624.7153 • technical support 800.932.6993 • www.amx.com
93-2178-13
REV: B
Step Five: Load the MMS Server Into the Rack
Once the Outer Rail/Bracket assemblies have been installed in the rack
cabinet, the MMS server can slide into the rack, using the Inner Server
Rails (already attached to the server chassis):
1.
Carefully align the front of the Outer Slide Rails (in the rack) with the
Inner Server Rails (on the MMS server chassis).
2.
Slowly slide the MMS server, into the outer slide rails. Keep the MMS
parallel to the floor when sliding the server rails into the slide rails.
Tilting the server up or down could result in damage to the slide rail
assembly.
3.
Push the locking tabs in to lock into place. The MMS server slides
into the rack until the Locking Release Tabs on the Inner Server Rails
engage the Outer Slide Rails.
Note: Be careful when pressing the Inner Server Rail release latches and
sliding the server into the rack. The slide rails could pinch your fingertips.
FIG. 4
Sliding the MMS server chassis into the rack
Inner Server Rail
Outer Slide Rail
Extension Bracket
Rack (front)