Texas Instruments 4000M - Manual (Page 195)

Using the AC Ada pt er
The AC Adapter - Charges the internal Battery Pack and
operates the computer on AC power whether or not a
Battery Pack is installed
c
Caution: Use only the AC Adapter supplied with your
computer. Another adapter can damage your computer.
To connect the AC Adapter, complete the following steps:
1. Set the power switch to the off (
s) position, or press
STANDBY to put the computer into standby mode.
2. Connect the female connector of the AC cord to the
inlet on the AC Adapter.
3. Hold the round connector from the AC Adapter and press
it into the matching jack on the rear panel of the
computer.
4. Plug the male end of the AC cord into a grounded wall
receptacle of the correct voltage.
5. If you plan to use other external devices with your unit,
connect the device to the computer before setting the
computer power switch to the on (|) position.
AC Adapter - Notebook
Using the AC Adapter
TravelMate Options 11-9