Ameriphone Q90 - Manual (Page 17)

D. Transfer
1. Press F10 to
send the message
Pls Hold.. . Your
TTY sends the
message and then
displays Hold Mode [ON]
Press Any Key to Release .
2. Turn on another TTY on the same
phone line. Using this TTY,
press Return three times and
the Q90 will automatically
hang up and turn off.
You can continue your call
on the other TTY.
Note: If your TTY does not have a
Return key, press Enter three times
instead.
CHAPTER 6
(CONTINUED)
1.Press F7 to
turn on
Hi-Speed
™
.
2.If both TTYs
have Hi-Speed
™
capability and are in Hi-Speed
™
mode, the Hi-Speed
™
light
will turn on and your call will
proceed at the higher rate.
If not, the Q90 will automatically
use the normal transmission
speed.
F8 F9 F11
& * ( )
7 8 9 0
SAVE HCO FLASH
F10
TRANSFER
E. Printing a Conversation
The Q90 can print conversations using
most printers that have a 36 pin
Centronics parallel port.
1. Preparing to Print a Conversation
1. Make sure the Q90 and the
printer are off. (If needed, hold
down Ctrl and press Power to
turn off the Q90.)
2. Connect one end of the printer
cable to the printer port on the
bottom of the Q90.
3. Connect the other end of the
printer cable to the printer.
Note: An optional printer cable is
available from Ameriphone.
2. Printing a Conversation with a
Dot-Matrix Printer
1. Turn on the printer and the Q90.
2. If you are using continuous
form-feed paper, follow
15
C. Hi-Speed™ Transmission
F6 F8 F9
^ & *
6 7 8
SAVE HC MSG 2
F7
Hi-SPEED