Konica Minolta bizhub 20 - Manual (Page 30)

Control panel setup
23
3
APIPA
3
The setting of On will cause the print server to automatically allocate a Link-Local IP address in the range
(169.254.1.0 - 169.254.254.255) when the print server cannot obtain an IP address through the Boot Method
you have set. (See Boot Method on page 17.) Choosing Off means the IP address does not change, when
the print server cannot obtain an IP address through the Boot Method you have set.
a Press Menu.
b Press a or b to choose Network.
Press OK.
c Press a or b to choose TCP/IP.
Press OK.
d
Press a or b to choose APIPA.
Press OK.
e
Press a or b to choose On or Off.
Press OK.
f Press Stop/Exit.
IPv6
3
This machine is compatible with IPv6, the next generation internet protocol. If you want to use the IPv6
protocol, choose On. The default setting for IPv6 is Off.
a Press Menu.
b Press a or b to choose Network.
Press OK.
c Press a or b to choose TCP/IP.
Press OK.
d Press a or b to choose IPv6.
Press OK.
e Press a or b to choose On or Off.
Press OK.
f
Press Stop/Exit.
Note
If you set IPv6 to On, turn off the power switch and then turn it back on to enable this protocol.