Konica Minolta bizhub 751 - Manual (Page 19)

5
Make sure that a message appears prompting you to turn OFF and then ON the main power
switch. Now, turn OFF and then turn ON the main power switch.
Check that all data has been overwritten and erased properly. Data is not erased properly if an
error occurs during the procedure. For more details, consult the Service Representative.
When the main power switch is turned off, then on again, wait at least 10 seconds to turn it on
after turning it off. if there is no wait period between turning the main power switch off, then on
again, the machine may not function properly. Here is the sequence, through which the main
power switch and sub power switch are turned on and off:
Turn off the sub power switch >
Turn off the main power switch > Turn on the main power
switch
> Turn on the sub power switch
After the main power switch has been turned on, quickly turn it off and give the machine to the
Service Engineer.
If the Overwrite All Data function is executed by mistake, contact the Service Engineer. For
more details, consult the Service Representative.