Konica Minolta bizhub PRESS 1052 - Manual (Page 17)

bizhub PRESS 1250/1250P/1052 2-7
2.2 Installation Procedures 2
6
Install the 2 duct covers.
% Be sure to install both of the duct covers on the out-
side. Wedge the resin member between the tabs of the
duct cover to install the covers as illustrated below.
7
Push in the tray until it locks into place.
Using Envelopes of 141 to 245 mm in Width
The following parts need to be installed when envelopes of the above size are used.
-
Regulation guide/Front
- Regulation guide/Rear
1
Pull out the tray.
2
Install the regulation guides (front/rear) onto the top of the
small size guides (front/rear).
% Be sure to install the regulation guides by pushing them
to the direction of arrow.
3
Push in the tray until it locks into place.