Konica Minolta PAGEPRO 9100 - Manual (Page 46)

Media 40
Page Margins
Margins are set through your application. Some applications allow you to set
custom page sizes and margins while others have only standard page sizes
and margins from which to choose. If you choose a standard format, you may
lose part of your image (due to imageable area constraints). If you can
custom-size your page in your application, use those sizes given for the
imageable area for optimum results.
Image Alignment
If for any reason, you need to change the image alignment, you can do so in
several different ways:
Adjust the margins or page size through your application (recommended
method).
Use the printer’s control panel (Administration/Engine/Image Alignment or
the Administration/Engine/Edge-to-Edge menu).
Use the PostScript translate and scale operators to reduce image size
and change its placement on the page (requires PostScript programming
knowledge).
Output Tray
The single face-down output tray has a capacity of 500 sheets of 20 lb
(75 g/m 2 ) bond paper. If the media stacks too high, your printer may
experience media jams, excessive media curl, or static buildup. Remove
transparency media as soon as it’s printed.
Media
Attention
Use only KONICA MINOLTA-approved media. For a list of currently
approved media, go to printer.konicaminolta.com. To order approved
transparencies, go to printer.konicaminolta.com.
Try printing your data on a plain sheet of paper first to check placement.
Media is fed either on the short or long edge, depending on the size of the
media. See “What sizes/weights of media can I use?” on page 37.
Test any stock (and the number of sheets of thick stock a media tray can
hold) thicker than 24 lb bond (90 g/m²) to ensure that its performance is
acceptable.