Konica Minolta bizhub 36 - Manual (Page 32)

bizhub 42/36 4-4
4.1 To begin operation 4
4.1.4 Connection and settings of network cable
To send image data over the network, such as the Internet Fax and PC-FAX (in network connection) func-
tions, connection and settings of the network cable are required.
Connection of network cable
Connect a UTP cable (category 5 or later recommended) connected to the network to the Ethernet connector
on the machine.
It supports 1000Base-T, 100Base-TX, and 10Base-T standards. In addition, TCP/IP (LPD/LPR, IPP), Web
services, IPX/SPX (NetWare), AppleTalk (EtherTalk) protocols are supported.
Network settings
An IP address must be assigned to the machine and settings, such as the SMTP server, must be specified in
order to use the machine on the network. For the detailed procedure, refer to the [User's Guide Administrator
Operations].
Specifying an E-mail address for this machine
An E-mail address must be registered to this machine to use the Internet Fax function. This E-mail address
is used for sending/receiving data. It is recommended that the E-mail address registered for the administrator
be used.
If the E-mail address registered for this machine is not specified, the From address must be entered for each
Internet Fax transmission. Note that Internet Fax transmissions are not possible if a From address is not en-
tered.
Reference
- If User Authentication is enabled, the E-mail address specified for each user will be From address.
d
Reference
For details on setting the E-mail address for this machine, refer to the [User's Guide Administrator Opera-
tions].