AutoPage C3-RS-625 - Manual (Page 11)

11
program the remote control transmitter to a second vehicle, follow the
instructions for Transmitter programming. All programming parameters
are the same except for the following:
For Regular Remote Control Transmitter:
1. Prior to pushing any button on the transmitter. Press the Select II
button first on the standard transmitter.
2. Once II button is pressed the LED on the transmitter will illuminate for
3.5 seconds. While the LED is illuminated, press the button for the
function you want to operate on the standard remote transmitter to
control a second vehicle security system.
For 2-way LCD Remote Control Transceiver:
2nd
Car Operation: While the “II” icon display on the LCD screen, you can
remote control and communicate with a second Autopage AM frequency
security system. It has two short “beep” sounds while pressing any button
of the LCD screen transceiver
1. Press and hold all four remote control buttons
simultaneously unit one long beep is heard. LCD
Programming has now been entered.
2. Within 5 seconds press and hold button until two
beeping sounds are heard and the “II” icon will
display on the LCD screen to indicate the second
transceiver pin code has been initiated.
3. To exit programming mode, take no action for five
seconds. The remote control will generate two long
beeps to indicate programming mode has been
exited.
Back to first Car Operation:
This will allow you to control and communicate with the first vehicles
security system.
1. Press and hold all four remote control buttons
simultaneously unit one long beep is heard.
Programming has now been entered.
2. Within 5 seconds press and hold button until one
beep sound is heard.
3. To exit programming mode, take no action for five
seconds. The remote control will generate two long
beeps to indicate programming mode has been
exited.