Konica Minolta bizhub C35P - Manual (Page 256)

Dual In-Line Memory Module (DIMM) 10-5
3
Using a screwdriver, remove two
screws.
4
Slide the panel slightly to the
down and lift it off the printer.
5
Insert the DIMM at an angle
(about 45°) into the connector,
making sure that the notch on
the unit aligns with the tab on
connector, and then press down
carefully until it clicks into place.
"
Be sure to handle the
DIMM by the edges only.
"
You will hear a click when
the DIMM is properly
placed.
6
Reinstall the panel and tighten two screws.
7
Attach the back cover and tighten four screws.
8
Reconnect all interface cables.