Konica Minolta Magicolor 5430 - Manual (Page 117)

Solving Other Problems 109
Printing
takes too
much time. The printer is set to a
slow printing mode
(for example, thick
stock or transpar-
ency). It takes more time to print on special
media. When using regular paper,
make sure that the media type is set
properly in the driver.
The printer is set to
Energy Saver mode. It takes time for printing to start in
Energy Saver mode. If you do not want
to use this mode, disable it.
The job is very com-
plex. Wait. No action needed.
The printer memory is
insufficient. Add more memory.
A toner cartridge for a
different region or a
non-genuine toner
cartridge is installed
(
INCORRECT
CART. X is dis-
played in the mes-
sage window).
Install a KONICA MINOLTA toner car-
tridge approved for your specific
printer.
Blank pages
come out
during print-
ing. One or more of the
toner cartridges are
defective or empty. Check the toner cartridges.
The wrong media is
being used. Check that the media type set in the
driver matches the media loaded in the
printer.
Printer
returned to
READY
before the
menu was
changed.
The printer was in the
menu structure with-
out a selection being
made within two min-
utes. When in the menu structure, select
your choice within 2 minutes.
Not all pages
print. The printer has the
wrong kind of cable,
or the printer is not
configured for the
correct cable and
port. Check your cable.
The Cancel key was
pressed. Make sure no one pressed the Cancel
key while your job was printing.
Symptom Cause Solution