Allied Telesis SB251-10 - Manual (Page 11)

Patch SB251-10 For SwitchBlade 4000 Series Switches and AT-9800 Series Switches 11
Patch SB251-10 for Software Release 2.5.1
C613-10361-00 REV J
The DPORT parameter in the ADD SWITCH HWFILTER command was
omitted when the configuration was generated. This issue has been
resolved.
The SET SWITCH PORT ACCEPTABLE command did not work correctly
on all specified port numbers. This issue has been resolved.
A warning message was generated when a slave line card was not
initialised, and the configuration script was not loaded. This issue has been
resolved.
RIP was not operating correctly because a MAC address search returned the
wrong port number. This issue has been resolved.
The ADD FIREWALL POLICY RULE command included an erroneous
check on port ranges for non-NAT rules. This check is now restricted to
NAT rules.
Executing the SET IP INTERFACE and SET IPX INTERFACE commands on
a SwitchBlade produced debugging output on the ASYN port. This issue
has been resolved.
A new value is now shown in the output of the SHOW QOS POLICY
command. This is the value of the port bandwidth used when the default
traffic class percentage bandwidth is set on a QoS Policy.
Adding a layer 2 filter on a SwitchBlade did not block traffic to the end host
as intended. This issue has been resolved.
On a SwitchBlade, PCI errors occurred periodically after a line card was
hotswapped. This issue has been resolved.
The board revision number for the slave control blade was erroneously set
to the same number as the master control blade. This issue has been
resolved.
If a port belongs to an enabled STP instance, but the port has been disabled
from STP operation with the DISABLE STP PORT command, the port will
not respond to ARP requests. This patch implements a workaround that
allows disabled STP ports to respond to ARP requests.
PCR: 03023 Module: SWI Network affecting: No
PCR: 03028 Module: SWI Network affecting: No
PCR: 03030 Module: SWI Network affecting: No
PCR: 03031 Module: FIREWALL Network affecting: No
PCR: 03034 Module: SWI Network affecting: No
PCR: 03037 Module: QOS Network affecting: No
PCR: 03039 Module: SWITCH, IPG Network affecting: No
PCR: 03043 Module: SWITCH Network affecting: No
PCR: 03047 Module: CORE Network affecting: No
PCR: 03428 Module: STP Network affecting: No