Allied Telesis Routers and Switches - Manual (Page 7)

Configure Load Balancer Redundancy on Allied Telesis Routers and Switches 7
Configure Load Balancer 2
Load balancer 2 is identical to load balancer 1, except for its:
• name (which is just a convenience and does not affect how it functions)
• public interface’s IP address
• private interface’s IP address
• load balancer redundancy peer, which is load balancer 1
Because the two load balancers are so similar, the following instructions do not explain the
steps—see the instructions for load balancer 1 for explanations.
set system name=LB-2
create vlan=vlan2 vid=2
create vlan=vlan3 vid=3
create vlan=vlan4 vid=4
add vlan=2 port=1
add vlan=3 port=2-4
add vlan=4 port=5
enable ip
add ip int=vlan2 ip=172.214.1.4 mask=255.255.255.0
add ip int=vlan3 ip=192.168.1.201
add ip int=vlan4 ip=192.168.2.1
enable firewall
create firewall policy=lb
set firewall policy=lb tcptimeout=5 udptimeout=5 othertimeout=5
add firewall policy=lb int=vlan2 type=public
add firewall policy=lb int=vlan3 type=private
add firewall policy=lb int=vlan4 type=private
1. Name the router
2. Create the VLANs
3. Add ports to the VLANs
4. Configure IP on the VLANs
5. Configure the firewall