Konica Minolta OpenText FaxPress - Manual (Page 22)

FaxPress Connector for Konica Minolta MFP Administrator Guide 14
Installed MFP Module extensions are listed in the top left pane, and
the DataFlow and individual Flowpoints are displayed in the bottom
left pane. In the top right pane, all of the processors that are
required by the Flowpoints are listed, and the separate instances of
each processor are listed in the bottom right pane. Current status
information is displayed for all objects listed in the FaxPress EDC
Monitor. Table A.1 defines each of the status columns in the right
pane.
Viewing and Clearing Processor Events
In addition to viewing processor activity in FaxPress EDC Monitor,
you can view and clear the processor Event Log. This section
describes how to view and clear processor events.
Table A.1 FaxPress EDC Monitor Status Definitions
Column
heading
Definition
Status The FaxPress External Document Connector
component’s status. Possible values are:
Failed - The component has shut down.
Hung - The component is no longer responding.
Job Errors - Errors prevented the image from
processing.
OK - The image was processed successfully.
Done The total number of fax images that have been
completed by this component.
Pending The total number of jobs currently queued for
processing by this component.
Errors The total number of processing errors that have
been logged by this component.
Warnings The total number of processing warnings that have
been logged by this component.
Bad Jobs The total number of jobs that could not be
processed and have been abandoned by this
component.
Activity The current active state of the component.
Possible values are:
Idle - The component is currently inactive.
Processing Job - The component is currently
processing a job.
Paused - The component has been paused. No
jobs will be processed.
Shut Down - The component service is currently
stopped.
Table A.1 FaxPress EDC Monitor Status Definitions
Column
heading
Definition