Konica Minolta KIP Color 80 - Manual (Page 45)

1-40
2. 8 Initial Cut
(Straighten the leading edge of roll media)
A new roll media tends to have a rough or folded leading edge. Initial Cut will easily straighten the
leading edge by cutting off such poor quality part of the media automatically. The selected roll
media is cut by 260mm long, and the portion of media after the cut is automatically ejected.
Roll Deck Selection Indicator (1), Roll Deck Selection Key (2), and Cut Key (3) are used for the
operation.
1 2 3
1 2 3 4
Paper Deck
K
C
M
Y
MF
D1
D2
D3
D4
D5
D6
D7
D8
D9
D10
Wire-Clean
Menu Enter Online
Copy Density
Select Cut
Operate as follows for making Initial Cut.
1. Select any Roll Deck number pressing the Roll Deck Selection Key. Green light turns on for the
selected Roll Deck number. Initial Cut will be done for selected roll media.
2. Press the Cut Key. The roll media of the selected Roll Deck is
automatically transported and its leading edge is cut off. The
portion of media after the cut is automatically ejected.
1 2 3 4
Paper Deck Select Cut
1 2 3 4
Paper Deck Select Cut
1 2 3 4
Paper Deck Select Cut
NOTE
When the KIP Color 80 is not available for the Initial Cut by
some reason like “warm up” or “door open”, all of 4 lamps of
the Roll Deck Selection Indicator go off.
Some Media manufactures / suppliers place tape or adhesive on the edge of the media to
prevent it from unrolling in the package. Any adhesive that remains on the media and is
transported through the printer will cause internal parts to become damaged or dirty.
REMOVE THIS AREA OF THE MEDIA MANUALLY PRIOR TO INSTALLING THE ROLL
IN THE PRINTER.
1 2 3 4
Paper Deck Select Cut