Aga Ranges F104010-01 - Manual (Page 6)

SERVICING - WARNING
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
6
10. To Change Cooktop Burner Orifice
Remove burner cap and head. Remove old jet.
Fit new orifice. Note the Wok burner has 2
orifices. Reassemble in reverse order. Check
appliance is gas sound.
11. To Change Cooktop Burner
Electrode
Lift off cooktop grates, remove burner cap.
Remove the screw holding the electrode. Pull
electrode vertically up sufficiently to grip the
lead between thumb and forefinger. Pull off the
electrode, but keep hold of the lead. Fit new
electrode to the lead. Fix electrode in burner
with screw. Replace burner cap. Check the
burner ignition. Replace grates.
12. To Remove or Change a Cooktop
Burner.
Remove the cooktop tray (see 3).
Center cooktop burners
Remove the control panel (see 2). The burners
are mounted in 2’s on cross supports.
Disconnect the burner feed pipes at the
burners. Remove the screw at the front holding
the cross support. Slide the support to the right
to release in from the rear location.
Lift the cross support and burners clear. The
burners are fixed to the cross supports with
screws underneath Remove the appropriate
burner and fit the new one. Reassemble in
reverse order. Check burner operation is
satisfactory.
Wok burners
Disconnect the burner feed pipes at the burner.
Fit the new one and reassemble in reverse
order. Check burner operation is satisfactory.
top of range with cooktop removed