ATEN UC-232A - Manual (Page 17)

- 17 -
Peripheral Installation
1. After you have finished the software installation procedures
for your operating system and have connected the UC-232A
to your computer, connect the peripheral device to the UC-
232A, and then turn the peripheral on.
2. Follow the Installation Wizard's on-screen instructions to
complete the installation.
Note: 1. This procedure only occurs the first time you connect
the peripheral. If your peripheral was previously
connected and configured for the RS-232 (COM) port,
after you perform the Adapter Installation and click
Finish, the driver will detect it and install it automatically.
However, some peripheral devices, such as older
PDAs, require that you re-install the software for the
peripheral device before it will work properly.
2. Under Windows 2000, if you connect a modem, you
must specify it as a Standard Modem.
uc232a.fm Page 17 Monday, July 23, 2007 3:36 PM