Xerox DocuColor 242-252-260 con built-in Fiery controller-16191 - Manual

Customer Release Notes
EFI Fiery
®
Color Server for Xerox DocuColor 242/252/260,
version 2.0
Part Number: 45059498
16 April 2007
Copyright 2007 © Electronics for Imaging, Inc.
This document contains information about the EFI Fiery Color Server for Xerox
DocuColor 242/252/260, version 2.0.
Before using the EFI Fiery Color Server for Xerox DocuColor 242/252/260, make copies of
these Customer Release Notes and the Quick Connect Guide and distribute them to all users.
N OTE : This document uses the term “Fiery Color Server” to refer to the EFI Fiery Color
Server for Xerox DocuColor 242/252/260. The term “copier” refers to the DocuColor 242/
252 and DocuColor 260 copiers.
System System software installation
If you install system software from a client computer over the network, and the installation
fails because of connection timeout, exit any applications and disable any virus protection
software or pop-up blocker on the client computer.
After installing, upgrading, or reinstalling software
After installing, upgrading, or reinstalling your system software, you must reboot the Fiery
Color Server.
Server loses connection or unresponsive
If you are using an older keyboard and mouse with PS-2 type connector, the Fiery Color
Server may not restart properly or may lose connection. This is caused by PS2-style
components which are not supported. EFI recommends using keyboard and mouse with USB
connector.
OS support OS support on client workstations
In addition to the operating system support listed in Welcome (on User Documentation CD),
the following operating systems are now supported: Intel-based Mac, Windows XP (64-bit),
and Windows Vista (32- and 64-bit).
Intel-based Mac
System requirements
• G3 800 MHz
• 500 MB RAM
• At least 80 MB of hard disk space for installation (500 MB recommended for writing full
previews of raster files and handling large PostScript and PDF files).
• At least 1024 x 768 monitor resolution