Audiovox RVMPKG1 - Manual (Page 5)

5
2. Press switch button #1 once to turn on the external signal input. The image
will be displayed as long as the ignition is turned on and the parking brake
is on.
3. To turn off the external signal input, press switch button #1on the mirror.
The external signal input will also be turned off if the parking brake is
released or the ignition key is turned off.
IV. Cellular Phone Hands-Free Operation
1. Attach the round metal adhesive disc to the back of your mobile phone while
not in use, and then attach the mobile phone adhesive magnetic seat to your
selected spot of the dash area. By placing your cell phone with the metal disc
over the center of the magnetic seat, your cell phone will be attached tightly to
the dash.
2. Plug in the 2.5mm hands free cable into your cell phone headset jack. The other
end of this cable should be connected to the control box mounted under the dash
area. Note. If your cell phone does not have a 2.5mm headphone jack then an
adapter must be used for your particular cell phone. Also not all cell phones are
compatible with this mirrors hands free circuit.
3. To answer a call, press the receiving button on your cell phone as usual, the
hands free system will engage automatically.
4. The volume of the other party’s voice can be adjusted by turning the volume
control under the bottom of the mirror on the right side.
5. To end the call, press the hang-up button. The hands free function will turn
off automatically and several seconds later the system will go back to its
original audio input.
6. For the different mobile phone, the quality of hands free voice can be adjusted
by switching the H-MIC-L switch J.