Xerox WorkCentre M118-M118i-6209 - Manual (Page 3)

Network Setup Using a Static IP Address
Xerox WorkCentre M118/M118i
3
Network Setup Using a Static IP Address
When the machine is powered on, it automatically uses DHCP to obtain its network configuration. To use a
static IP address, DHCP must be turned off and the IP address, gateway address, subnet mask, and
DNS Server address must be entered manually.
Pre-requisites for Using a Static IP Address
Before you begin, obtain the following information from your network administrator:
Connecting the Machine Using a Static IP Address
1. Turn on the machine.
2. When the machine is Ready, press the Log In/Out button.
3. Press the Select button below the display to select System Settings .
a. Use the numeric keypad to enter the Password . The default password is 11111.
b. Press the Select button to select Confirm .
Turn DHCP Off
1. Press the Select button to highlight Print Settings , and then press the Enter button.
2. Press the the Enter button to select Network/Port .
3. Press the Select button until you see TCP/IP Settings on the display, and then press the Enter button.
4. Select Get IP Address , and then press the Enter button.
5. Select Manual , and then press the Enter button.
6. Press the Exit button.
Set the IP Address
1. Press the Select button until you see IP Address on the display,, and then press the Enter button.
2. If there is an incorrect IP address in the field, press the Clear button to delete the address.
3. Use the numeric key pad to enter the first number of the IP address, and then press the Right Arrow button
to move to the next field.
4. Repeat Step 3 to enter the remaining numbers.
5. Press the Enter button to accept the address.
6. Press the Exit button.
IP Address: __________ . __________ . __________ . __________
Gateway Address: __________ . __________ . __________ . __________
Subnet Mask: __________ . __________ . __________ . __________
DNS Server Address: __________ . __________ . __________ . __________