Audiovox 50-0286x-019 Series - Manual (Page 5)

5
9. Route video and audio cables from overhead
console location to passenger’s side B pillar.
Down B pillar and underneath scuff panel.
Up passenger’s side kick panel and across the
bottom side of dash panel. See Figure 7.
10. Align holes in rear of CD player with holes in mounting
bracket.
11. Secure CD player to mounting bracket using the (2) two
original screws. See Figure 8.
12. Place mounting bracket in vehicle in approximate position
where original console was located.
13. Connect CD wiring and insert video cables and wiring
through opening in rear of mounting bracket.
14. Position mounting bracket against plastic panels
that original console secured to.
NOTE: Tabs on lower bracket aligns with slots
on bracket on floor of vehicle.
15. Using an awl or similar tool align holes in
bracket with holes in plastic panel and threaded
clips behind panel. See Figure 9.
16. Secure mounting bracket using (2) two #8 X
1 1/2" screws (item 1 pg. 2). See Figure 9.
FIGURE 8
FIGURE 7
FIGURE 9