Agri-Fab 45-02152 - Manual (Page 6)

6
18.Place a 5/16" flat washer onto the end of the flow
control rod. Insert the end of the rod through the
slot in the flow control mounting bracket and
through the hole in the flow control link. Secure
with a 3/32" x 3/4" cotter pin. See figure 9.
FIGURE 9
19.Hook the free end of the flow control rod through the
hole in the slide gate bracket located near the bottom
of the hopper. See figure 10.
FIGURE 10
20.Assemble the flow control mounting bracket to the
hitch tube using two 1/4" x 1-1/2" hex bolts, six 5/16"
flat washers and two 1/4" hex lock nuts as shown
in figure 11.
Do not tighten at this time.
FIGURE 11
FLOW
CONTROL
ROD
FLOW
CONTROL
LINK
3/32"
COTTER
PIN
5/16" FLAT
WASHER
SLOT
FLOW CONTROL
MOUNTING BRACKET
1/4" x 1-1/2"
HEX BOLT
1/4" HEX
LOCK NUT
5/16" FLAT
WASHER
16.Assemble the flow control arm to the flow control
mounting bracket using a 1/4" x 3/4" hex bolt, two
nylon washers and a 1/4" hex lock nut as shown in
figure 8.
Tighten carefully. The flow control arm
should be snug, but should pivot with no more
than a slight resistance.
17.Assemble the vinyl grip. See figure 8.
FIGURE 8
1/4" x 3/4"
HEX BOLT
1/4" HEX
LOCK NUT
FLOW CONTROL
MOUNTING
BRACKET
FLOW
CONTROL
ARM
(2) NYLON
WASHERS
VYNIL GRIP