Agri-Fab 45-01872 - Manual (Page 5)

5
9.Assemble a spacer and a 1-5/8" flat washer onto the
end of the axle that has the large hole. See figure 4.
10.Place the drive wheel onto the axle (air valve to outside)
and secure with a 1/4" x 1-3/4" hex bolt and a 1/4" hex
lock nut. See figure 4.
FIGURE 4
11.Turn the spreader upright on its wheels.
12.Assemble the hitch bracket to the top of the hitch tube
using two 3/8" x 1-1/4" hex bolts, 3/8" lock washers and
3/8" hex lock nuts. See figure 5.
13.Assemble the hitch pin through the hitch bracket and
the hitch tube and secure with the hair cotter pin. See
figure 5.
FIGURE 5
14.Assemble the flow control link (end with small hole) to
the flow control arm using a 1/4" x 3/4" hex bolt, a nylon
washer and a 1/4" hex lock nut as shown in figure 6.
Tighten carefully. The flow control link should not be
loose but should pivot with no more than slight resis-
tance.
FIGURE 6
1/4" HEX
LOCK NUT
1/4" x 1-3/4"
HEX BOLT
DRIVE WHEEL
AIR VALVE
SPACER
1-5/8" DIA.
FLAT WASHER
3/8" x 1-1/4"
HEX BOLT
3/8" LOCK
WASHER
3/8" HEX
LOCK NUT
HITCH PIN
HAIR COTTER PIN
FLOW CONTROL
LINK FLOW
CONTROL
ARM
1/4" HEX
LOCK NUT
1/4" x 3/4"
HEX BOLT
SMALLEST
HOLE
NYLON
WASHER