Airlink101 AWLH3026T - Manual (Page 20)

20
Advance Setting
Disable Radio: Check the box to disable the radio signal
Fragmentation Threshold: Set the desired fragmentation threshold
RTS Threshold: Set the desired RTS threshold
Frequency:
802.11b/g switches automatically between 802.11b and 802.11g speed
depending on the other wireless device. 802.11b will only connect at 802.11b speed (11
Mbps or lower).
Start ad hoc network: Choose the appropriate frequency for your ad-hoc network
Ad-Hoc Channel: Choose the desired channel for your ad-hoc network.
All devices in
the ad-hoc network must use the same channel.
Power save Mode: Choose among Disable, Max Save, Fast Save
• Disable - This default setting consumes the most power.
• Max Save - This setting consumes the least power.
• Fast Save - This setting consumes half the power.
Tx Burst: Choose to enable or disable burst transmission.
WLAN type to connect
Infrastructure and Ad-Hoc network: For connecting to either an access point or a
peer-to-peer network without an access point.
Infrastructure: For connecting to an access point only
Ad-Hoc: For connecting directly to another wireless client without using an Access
Point or wireless router. (Both wireless clients must be set to Ad-Hoc mode).
Automatically connect to non-preferred networks: Check the box to automatically
connect to non-preferred networks upon startup.