6 the inlet hose, 7 water-stop device, 8 water drainage – AEG T65170AV User Manual
Page 41
16.6 The inlet hose
20
O
20
O
45
O
45
O
• Connect the hose to the back appliance.
Turn the inlet hose only left or right.
• Loose the ring nut to set it in the correct
position.
• Connect the water inlet hose to the cold
water tap with 3/4 thread.
CAUTION!
Make sure that there are no
leaks from the couplings.
Do not use an extension hose if the inlet hose is too short. Contact the
service centre for the replacement of the inlet hose.
16.7 Water-stop device
A
The inlet hose has a water stop device. This
device prevents water leaks in the hose
because of its natural ageing.
The red sector in the window «A» shows this
fault.
If this occur, close the water tap and contact
the service centre to replace the hose.
16.8 Water drainage
There are different procedures to connect the drain hose:
With the plastic hose guide:
ENGLISH
41