AEG AGN71800F0 - Manual (Page 15)

WHAT TO DO IF…
WARNING!
Before troubleshooting, discon-
nect the mains plug from the
mains socket.
Only a qualified electrician or
competent person must do the
troubleshooting that is not in this
manual. There are some sounds during
normal use (compressor, refriger-
ant circulation).
Problem Possible cause Solution
The appliance does
not operate. The Pi-
lot light does not
flash. The appliance is switched
off. Switch on the appliance.
The mains plug is not con-
nected to the mains sock-
et correctly. Connect the mains plug to
the mains socket correctly.
The appliance has no
power. There is no voltage
in the mains socket. Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
The Pilot light flash-
es. The appliance is not work-
ing properly. Contact a qualified electri-
cian.
The Alarm light flash-
es. The temperature in the
freezer is too high. Refer to "Excessive Tem-
perature Alarm"
The acoustic alarm
sounds The temperature in the
freezer is too high. Refer to "Excessive Tem-
perature Alarm"
The door is left open. Close the door.
The compressor op-
erates continually. The temperature is not set
correctly. Set a higher temperature.
The door is not closed cor-
rectly. Refer to "Closing the
door".
The door has been
opened too frequently. Do not keep the door open
longer than necessary.
The product temperature
is too high. Let the product tempera-
ture decrease to room tem-
perature before storage.
The room temperature is
too high. Decrease the room temper-
ature.
The Fast Freeze function is
switched on. Refer to "Fast Freeze func-
tion".
The temperature in
the freezer is too
low. The temperature regulator
is not set correctly. Set a higher temperature.
ENGLISH
15