Troubleshooting, Problemen oplossen, It de fr nl en en – AEG LM5100-U User Manual

Page 15

Advertising
background image

15

it

DE
FR
NL
EN

EN

Troubleshooting

Problems

Causes

Solutions

The machine does not turn on.

The machine is not connected to the

power source.

Connect the machine to the power source.

Contact Electrolux customer service.

The pump is very noisy.

No water flow.

No water in the tank.

Fill the tank with fresh drinking water.

Check correct water tank position.

The loading lever doesn’t reach the

brewing position.

Capsule inserted incorrectly.

Empty the used capsule compartment.

Repeat the sequence, open and close the lever. If that

is not enough remove the capsule manually from the

compartment after unplugging the machine safely.

The coffee is cold.

Preheat the cup with the hot water.

The coffee is brewed too fast, the

brewed coffee is not creamy.

Capsule already used.

Open the lever and insert a new capsule.

Coffee is not brewed or brewed in

drips only.

Coffee spout is clogged.

Brew water without the use of a capsule.

If the machine does not heat up.

Thermoblock is not working properly.

Contact Electrolux customer service.

The machine requires a lot of time

to heat up.

The machine has limescale build up.

Descale the machine.

Coffee is not brewed and coffee light

flashes very quickly (0.25s on and

0.25s off).

Thermal sensor is not working properly.

Contact Electrolux customer service.

NL

Problemen oplossen /

Problemen

Oorzaken

Oplossingen

Het apparaat gaat niet aan.

De stekker van het apparaat zit niet

goed in het stopcontact.

Steek de stekker in het stopcontact.

Neem contact op met Electrolux Service

De pomp maakt veel lawaai.

Er komt geen water.

Het waterreservoir is leeg.

Vul het waterreservoir met schoon drinkwater.’

Controleer de juiste positie van de watertank.

De laadhendel bereikt niet de

brouwpositie.

Cupje verkeerd ingevoerd.

Leeg het gebruikte capsulecompartiment.

Herhaal de volgorde, open en sluit de hendel. Als dat

niet voldoende is, dient u het cupje te verwijderen uit

het compartiment nadat u de stekker van de machine

veilig uit het stopcontact heeft gehaald.

De koffie is te koud.

Warm de kop voor met heet water.

De koffie is te snel gebrouwen, de

gebrouwen koffie is niet romig.

Cupje al gebruikt.

Open de hendel en plaats een nieuw cupje.

Koffie wordt niet gebrouwen of

komt er alleen druppelend uit.

Het koffiemondstuk is verstopt.

Water zetten zonder het gebruik van een capsule.

Als de machine niet warm wordt.

Thermoblock werkt niet goed.

Neem contact op met Electrolux Service

De machine heeft lang nodig om op

te warmen.

De machine heeft kalkaanslag.

Ontkalk de machine.

Er wordt geen koffie gezet en het

koffielampje knippert heel snel (0.25

s aan en 0.25 s uit).

Temperatuursensor werkt niet goed.

Neem contact op met Electrolux Service

Advertising
This manual is related to the following products: