Hints and tips, 1 ecological hints, 3 deactivating the tank indicator – AEG T88595IS User Manual

Page 17

Advertising
background image

If the drying cycle is completed, the
symbol flashes on the display. If the

Buzzer option is on, the acoustic signal

sounds intermittently for 1 minute.

If you do not turn off the

appliance, the crease guard

phase starts. Laundry can be

removed during this phase.

To remove the laundry:
1. Push the On/Off button for 2

seconds to turn off the appliance.

2. Open the appliance door.

3. Remove the laundry.

4. Close the appliance door.

10. HINTS AND TIPS

10.1 Ecological hints

• Spin good the laundry before drying.

• Use the load volumes which are

specified in the programme chart.

• Clean the filter after each drying

cycle.

• Do not use fabric softener to wash

and then dry. In the tumble dryer

laundry becomes soft automatically.

• Use the condensate as distilled water,

e.g. for steam ironing. If it is necessary

clean the condensate before (e.g.

with a coffee filter) to remove possible

small pieces of fluff.

• Always keep the airflow slots on the

bottom of the appliance clear.

• Make sure that is good airflow in the

appliance installation position.

10.2 Adjustment of the

remaining laundry moisture

degree

To change the default degree of the

remaining moisture of the laundry:
1. Turn on the appliance.

2. Wait approximately 8 seconds.

3. Select 1 of available programmes.

4. Push at the same time and hold

down the Dry Plus and Spun at RPM

buttons.

One of the symbols goes into the view

on the display:

- the maximum dry laundry
- the more dry laundry
- the standard dry laundry

5. Push the Start/Pause button again

and again until you set necessary

degree.

6. To memorise the setting, push at the

same time the Dry Plus and Spun at

RPM buttons for approximately 2

seconds.

10.3 Deactivating the Tank
indicator

1. Turn on the appliance.

2. Wait approximately 8 seconds.

3. Select 1 of available programmes.

4. Push at the same time and hold

down the Dry Plus and Buzzer

buttons.

One of 2 configurations is possible:

• the Tank indicator:

is on and

the symbol

goes into the

view - the water container

indicator is permanently on

• the Tank indicator:

is off and

the symbol

goes into the

view - the water container

indicator is permanently off

ENGLISH

17

Advertising