AEG F99009W0P - Manual (Page 12)

6.3 Filling the rinse aid dispenser
M AX
1 2 3
4 + -
A B
D
C
1. Press the release button (D) to open
the lid (C).
2. Fill the rinse aid dispenser (A), no
more than the mark 'max'.
3. Remove the spilled rinse aid with an
absorbent cloth to prevent too much
foam.
4. Close the lid. Make sure that the re-
lease button locks into position.
You can turn the selector of the
released quantity (B) between
position 1 (lowest quantity) and
position 4 (highest quantity).
The display shows a message
when it is necessary to refill the
rinse aid dispenser. The message
stays off while a programme op-
erates.
7. DAILY USE
1. Open the water tap.
2. Press the on/off button to activate
the appliance.
• If the display shows the salt mes-
sage, fill the salt container.
• If the display shows the rinse aid
message, fill the rinse aid dispens-
er.
3. Load the baskets.
4. Add the detergent.
• If you use combi detergent tablets,
activate the Multitab option.
5. Set and start the correct programme
for the type of load and the degree
of soil.
7.1 Using the detergent
20
30 M AX
1 2 3
4
+ -
A B
C
1. Press the release button (B) to open
the lid (C).
2. Put the detergent in the compart-
ment (A) .
3. If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appli-
ance door.
4. If you use detergent tablets, put the
tablet in the compartment (A).
5. Close the lid. Make sure that the re-
lease button locks into position.
12 www.aeg.com