AEG FAVORIT 99015 VI0P - Manual (Page 15)

A1
A2
2. To disassemble the filter (A), pull
apart (A1) and (A2).
3. Remove the filter (B).
4. Wash the filters with water.
5. Before you put the filter (B) back,
make sure that there are no residues
of food or soil in or around the edge
of the sump.
6. Make sure that the filter (B) is cor-
rectly positioned under the 2 guides
(C).
7. Assemble the filter (A) and put it
back in filter (B). Turn it clockwise
until it locks.
An incorrect position of the filters
can cause bad washing results
and damage to the appliance.
9.2 Cleaning the spray arms
Do not remove the spray arms.
If the holes in the spray arms are clog-
ged, remove remaining parts of soil with
a thin pointed object.
9.3 External cleaning
Clean the appliance with a moist soft
cloth.
Only use neutral detergents. Do not use
abrasive products, abrasive cleaning
pads or solvents.
9.4 Internal cleaning
If you regularly use short duration pro-
grammes, these can leave deposits of
grease and limescale inside the appli-
ance.
To prevent this, we recommend to run
long duration programmes at least 2
times per month.
10. TROUBLESHOOTING
The appliance does not start or it stops
during operation.
Before you contact the Service, refer to
the information that follows for a solu-
tion to the problem. With some problems, the display
shows a message and the TimeBeam
shows an alarm code.
Display TimeBeam Problem
OPEN THE TAP The appliance does not
fill with water.
DRAIN BLOCKED The appliance does not
drain the water.
ENGLISH
15